106
command-line! This option is intended to
be used only with the dbupdate script.
--allfiles[={on,off,yes,no,1,0}] Scan all files
regardless of the extension. By default,
the setting is on. (In previous versions,
this option was called 'dumb'.)
--exclude=path Do not scan the given path.
--exclude-from=file Do not scan paths listed in the file.
Paths should be absolute paths ending
with a newline character.
--extensions=ext,ext,... Specify the list of filename
extensions to be scanned. You can use
“?” or “*” as wildcard characters.
The default list is:
*
--help Show the short help of command line
options and exit.
--input Read files to scan from the standard
input.
--libra[={on,off,yes,no,1,0}] Enable/disable the
Libra scanning engine for the scan and
the disinfection. If any engine is enabled,
all other engines are disabled unless
explicitly enabled.
To Next Page
Loading...
Need help?
General
