950N 11 732708 - Rev. C
ENGLISH
For electrical cable installation, use adequate rigid and/or flexible tubes. Always separate the
low-voltage accessories connection cables from the power supply cables. To avoid possible
interference, use separate sheathing.
5 ELECTRICAL PREPARATIONS
1. 950 N Operator
2. Microwave radar / Passive infrared sensor
3. Key release for external use (KEY command)
4. Emergency open/close button
5. KP-CONTROLLER programming unit (optional)
6. KP-CONTROLLER locking key switch (optional)
7. Electric lock 24V= max 0.5 A
8. Shunt box
tubes/couplings, available commercially.
Fig.3
7) Assemble the sliding block d with the springs j
b .
9) Manually pull the arm g inward and secure the track to
the closed door using two M6 screws.
10) Insert the two lateral plugs a in the track.
11) Manually verify that the door freely opens and closes
completely and stops on the mechanical stops.
To Next Page
Loading...
