FAAC A1400 AIR RD - Motors and Encoders; Motor Block XB LOCK and Monitoring (OPTIONAL)

A1400 AIR RDT 55 532119 04 - Rev. C
MAIN
F1
J10
J14
J11
J12
J12
J11
DL11
J13
V G
I
I+
I-
J5
V G
E
E+
E-
J6
V G
S1
G
T
J1
V G
S2
G
T
J2
V G
S3
G
T
J3
V G
S4
G
T
J4
V RX TX G
J8
E1 G E2
J7
T1 G
T2
R1
G R2
J9
V G 01 02 02
J22
J21
V
G
I1
I2
G
I3
I4
V
J18
G CH CL G
J13
73
74
1
2
B
C
1
2
2
3
1
A
B
C
   
J13
2
1
2
3
4
5
1
Translation of the original instructions
ENGLISH
12.3 MOTORS AND ENCODERS
1. Connect motor M1 to connector J11.
2. Connect the encoder cable of motor M1 to connector J12.
3. Extend the RED and BLACK cables of the AUX_Motor (use the
extension cable and connector supplied).
4. Connect the AUX_Motor to the connector on the auxiliary board
73-

.

AUX_MOTOR DRIVING DIRECTION
In case of incorrect connection, the board goes into error 28: the entry
direction of the connector must be inverted.
12.4 MOTOR BLOCK XB LOCK AND
MONITORING OPTIONAL
!
ALWAYS DISCONNECT the power supply and disconnect the emergency
battery before inserting or disabling the motor block, in order not to
damage the device.
1. Connect the motor release monitor (IF INSTALLED) on the release
terminal block 74-C.
2. Connect the motor block to the control board by means of the
wired connector 74-

.
3. Program motor block operation (
EL
EL) and enable monitoring
(
SU
SU) (IF INSTALLED).
A
EL
EL=
0
0 (motor block not present )
EL
EL=
1
1 (block inserted in NIGHT-TIME mode )
EL
EL=
2
2 (block inserted in NIGHT-TIME and OPEN mode)
C
SU
SU=
Y
Y (monitoring enabled - IF INSTALLED)

In the event of malfunctioning of the motor block the system signals
ERROR 26 on the display and on SDK EVO.
With SDK EVO the motor block operation may be programmed with
several options.
In the event of mains power failure, if the battery runs out the block
remains on.
1
green
C
Motor block monitoring
(IF INSTALLED)
2
pink
B Motor block microswitch
3
yellow
4
white
A Motor block
5
brown
black
red
Connection
AUX MOTOR