FAAC B614 - Page 25

19 20
18
B614 23 732998 - Rev.A
2
2
21
1
3
6
5
Translation of the original instructions
ENGLISH
5. (18) Insert beam 1 in the lever.
!
To make the insertion of the beam easier, use a stand
for resting it at the end.
6. Line up the two holes underneath (slide the lower
edging temporarily to uncover the holes).
7. Fix the beam with screws 2, interposing the washers
(reposition the lower edging).
8. (19) Insert cover 1 and fix it with screw 2, interpo-
sing the washer.
9. Insert the cover 3 at the end of the beam.
!
Leave the beam supported to take the weight until
the installation of the spring is complete (20).