What to do if the FAAC B680H Automatic Barriers does not open and does not close?
If your FAAC Automatic Barrier is not opening or closing, verify that the STOP LED is not active. Also, check the motor and encoder connections.
What to do if FAAC B680H does not close?
If your FAAC Automatic Barrier is not closing, ensure that the automation has not been released and check the driving direction of the motor. Also, ensure that the LED status of the controls, loops, safety devices and EMR are not active.
What to do if FAAC B680H Automatic Barriers does not open?
If your FAAC Automatic Barrier is not opening, ensure that the automation has not been released. Also, check the driving direction of the motor.
Why FAAC B680H Automatic Barriers moves very slowly?
If your FAAC Automatic Barrier is moving very slowly, check the force set and ensure that the beam is balanced. Also, make sure that the parameter cF has been set according to the length of the beam. If the barrier is working on battery, ensure that the battery is charged.
Why FAAC B680H Automatic Barriers moves irregularly?
If your FAAC Automatic Barrier moves irregularly, ensure that the automation has not been released and check the driving direction of the motor.
How to troubleshoot FAAC Automatic Barriers if it does not perform the setup?
If your FAAC Automatic Barrier does not perform the setup, ensure that the automation has not been released and that there is power. Also, check the motor and encoder connection.
What to do if FAAC B680H closes rather than opening?
If your FAAC Automatic Barrier closes instead of opening, or vice versa, invert the phases in the motor connection and carry out the setup.
How to fix FAAC Automatic Barriers if it moves irregularly and is very noisy?
If your FAAC Automatic Barrier moves irregularly and is very noisy during the opening and closing cycles, make sure there is no air in the hydraulic circuit; bleed it if necessary.
General| Power Consumption | 220 W |
|---|---|
| Duty Cycle | 100% |
| Operating Temperature | -20°C to +55°C |
| Protection Class | IP54 |
| Power Supply | 230V AC (+6% -10%), 50 (60) Hz |
| Motor Type | Asynchronous |
| Opening Time | 1.5 - 6 seconds |
| Maximum Boom Length | 8.3 m |
To Next Page
