EasyManua.ls Logo

FAAC B680H - Fitting the Spring Assembly

FAAC B680H
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
B680H 19 732719 - Rev.D
Translation of the original instructions
ENGLISH
H1
Loop 1 articulated lorry function
This function lets you increase the level of sensitivity at the time of detection, to allow correct
detection even in case of very tall vehicles or during the transit of a tractor and trailer.
Y enabled
no disabled
Y
H2
Loop 2 articulated lorry function
This function lets you increase the level of sensitivity at the time of detection, to allow correct
detection even in case of very tall vehicles or during the transit of a tractor and trailer.
Y enabled
no disabled
Y
t
Work time (time-out)
Maximum work time of the automated system before the motor stops, if the open or close position
is not reached. The value can be set from
O to 59 sec. in one second steps. Next, the display
changes to minutes and tenths of a second (separated by a decimal point) and time is adjusted
in 10-second steps up to the maximum value of
4.1 minutes.
30
dr
Red light brightness (OUT 5)
Changing this value increases or decreases the output voltage for OUT 5, changing the bright-
ness of the rope light.
04
dG
Green light brightness (OUT 6)
Changing this value increases or decreases the output voltage for OUT 5, changing the bright-
ness of the rope light.
04
St
STATUS OF THE AUTOMATED SYSTEM:
Exit from programming, storage of data and automated system status display.
6.3 Pre-De ned Parameter Sets
The table below shows, for each set of pre-defined parameters, the
values that they will load in the board memory.
BASIC programming
cF
01 02 03 04 05 06
dF
YYYYYY
Ct
MA MA MA MA MA MA
bu
no no no no no no
LO
EEEEEE
PA
20 20 20 20 20 20
So
10 10 10 10 10 10
Sc
10 05 05 04 02 02
L1
no no no no no no
L2
no no no no no no
S1
05 05 05 05 05 05
S2
05 05 05 05 05 05
ADVANCED programming
The following table shows, for each set of pre-defined parameters,
the values that they will load in the board memory, in ADVANCED
programming.
cF
01 02 03 04 05 06
FO
25 25 30 28 30 40
FC
25 25 30 28 30 40
PF
no no no no no no
tP
00 00 00 00 00 00
oc
30 30 30 30 30 30
FS
no no no no no no
o1
04 04 04 04 04 04
P1
no no no no no no
o2
03 03 03 03 03 03
P2
no no no no no no
o3
19 19 19 19 19 19
P3
no no no no no no
o4
01 01 01 01 01 01
P4
no no no no no no
o5
02 02 02 02 02 02
P5
no no no no no no
o6
04 04 04 04 04 04
P6
no no no no no no
o7
01 01 01 01 01 01
AS
no no no no no no
nc
00 00 00 00 00 00
nC
00 00 00 00 00 00

Table of Contents

Other manuals for FAAC B680H

Related product manuals