UK/IRL
32 < < < <
Setting the right transmission code
The receiver has to learn the code from the transmitter, which is already done at the
factory. However the code disappears if the receiver is disconnected from the mains for a
longer period.
1. Push the "mod" button on the receiver and hold it for 3 seconds.
2. The green control lamp will light up and stay on. Repeat this step if it doesn't.
3. Push a button on the remote control. The control lamp on the receiver should now go
out.
4. Again push a button on the remote control. The lamp starts flashing and will switch off
eventually.
5. The receiver now recognizes the remote control. The remote control now functions.
6. Check if you can hear a sound and the motor runs when you push a button on the
remote control.
To Next Page
Loading...
