Fagor 101 - Page 103

- 4 -
Software Version 2.03 (January 1999)
1. ADDITIONAL MOVEMENT WITH G75
When probing at high speed, it could stop abruptly making the axis overshoot the programmed position and having
to move back into position.
In previous versions of the CNC 101 S, machine parameter P82 could be used to minimize this sometimes undesirable
effect.
This parameter indicates to the CNC the distance the axis must move after receiving the probe signal, thus stopping
smoothly.
From this version on, this feature will also be available on the "102 S" CNC model and parameter P83 indicates the
distance the Y axis must move after receiving the probe signal.
Therefore: P82 indicates the distance the X axis must move after receiving the probe signal.
P83 indicates the distance the Y axis must move after receiving the probe signal.
Possible values: From 1 to 65535 microns.
From 1 to 25801 tenth-thousandths of an inch.
SUBSIDIARIES
Spain Fagor Automation Catalunya
France Fagor Automation Systèmes
Germany Fagor Industriecommerz GmbH
Italy Fagor Italia S.R.L.
United Kingdom Fagor Automation UK Ltd.
Switzerland Fagor Automation Suisse S.à r.l.
Portugal Fagor Automation Ltda.
USA Fagor Automation Corp.
Fagor Automation West Coast
Fagor Automation East Coast
Canada Fagor Automation Ontario
Fagor Automation Quebec
Headquarters (SPAIN): Fagor Automation S. Coop.
Bº San Andrés s/n, Apdo. 144
E-20500 Arrasate - Mondragón
Tel: (34)-943-719200
Fax: (34)-943-791712
(34)-943-771118 (Service Dept.)
www.fagorautomation.mcc.es
E-mail: info@fagorautomation.es
Brazil Fagor Automation do Brasil Com. Imp. Exp.
Ltda.
China, P.R. Beijing Fagor Automation Equipment Co. Ltd.
Beijing Fagor Automation Equipment Ltd.
Nanjing Office
Beijing Fagor Automation Equipment Co.Ltd.,
Guangzhou Rep.Office
Fagor Automation (Asia) Ltd. (Hong Kong)
Korea Fagor Automation Korea Ltd.
Taiwan Fagor Automation (Asia) Ltd. Twn. Branch
(HK)
Singapore Fagor Automation (S) Pte. Ltd.