Section:Chapter: 4
Page
PROGRAM EDITING8
* Press [A+] and [A-] to select the new function which, in this case, is "Y".
* Key in the new value which, in this case, is "120".
* Press [ENTER] for the CNC to assume this new block.
Attention:
To change more than 2 functions on the same block, proceed as follows:
· Modify the first function.
· Press to find the next function.
· Modify the other function.
· Press [ENTER] for the CNC to assume these changes.
The CNC does not assume the changes until [ENTER] is pressed.
If when pressing [ENTER], the block number keeps blinking (top display),
it means that there is an error in the edited block and it is not accepted into
memory.
BLOCK MODIFICATION
To Next Page
Loading...
