52 While monitoring the "double feedback", the actual deviation (slippage) has exceeded its maximum value set by
machine parameter P110.
101 DNC error. Wrong command.
102 DNC error. Error when reading a key code.
103 DNC error. An incorrect block has been sent.
104 DNC error. Error when reading the number of the first block of the active program.
105 DNC error. Incorrect block number.
106 DNC error. The CNC is in execution
107 DNC error. Locked key.
108 DNC error. Wrong key code.
109 DNC error. Negative coordinate for a rollover axis.
110 DNC error. Wrong arithmetic parameter number.
111 DNC error. Arithmetic parameter exponent too large.
112 DNC error. Wrong arithmetic parameter value.
113 DNC error. When requesting the contents of several blocks (RN code), the first block number is greater than the
last block number. For example: RN100.50
114 DNC error. The CNC machine parameters are locked.
115 DNC error. The CNC part-program memory is protected.
116 DNC error. A block has been sent which contains too many characters. The maximum is 80 characters when using
blank spaces as separators and 45 when otherwise.
117 DNC error. A program block has been sent in disagreement with the machine parameters.
To Next Page
Loading...
