Fagor AXD 1.08 - Page 46

Power supplies
94
2.
POWER SUPPLIES
Non-regenerative power supplies
46
DDS
HARDWARE
Ref.1310
Other connectors
X1 connector
The communication between all the modules that make up the DDS ser-
vo drive system is established through connector X1.
A ribbon cable is provided with each power supply or drive module for the
connection.
X2 connector
The power supply module may be controlled through connector X2.
F. H2/11
Connection of the internal bus between modules through connector X1.
F. H2/12
Control of the power supply module through connector X2.
Note. Pin 4 “Power Bus Enable” of connector X2 located on the front of
PS-65A power supplies is not used at this time.
Error Reset
7
1
Gnd
System
Speed Enable
System ok
1
2
3
4
5
6
7
X2
PS-25B4
Phoenix
5.08 mm
Error Reset
1
Gnd
System
Speed Enable
System ok
1
2
3
4
5
6
7
X2
PS-65A
Phoenix
5.08 mm
10
+24 VDC
0 VDC
8
9
10