Fagor CNC 8055i Manual

Page 48 of 50
CNC 8055 / CNC 8055i
Parameters
accessible from the
oscilloscope or
OEM subroutine
N
EW
F
EATURES
(S
OFT
M: 7.1
X
)
50
8 Parameters accessible from the oscilloscope or OEM
subroutine
8.1 Axis parameters that may be modified from the oscilloscope
The following axis machine parameters may be modified.
Indicate the axis and the parameter number separated by a dot.
Example: [X.P18], [Z.P23].
8.2 General parameters modifiable from the oscilloscope
The following general machine parameter (needed to adjust the
machine) may be modified from the oscilloscope.
Enter the indicator of the general parameter and the parameter
number separated with a dot. Example: [G.P161].
8.3 Machine parameters modifiable from an OEM program
All the parameters modifiable from the oscilloscope can also be
changed from an OEM program using the following variables.
The new values are updated according to the tables described in
chapter
32 Oscilloscope function
It is not necessary to press
[RESET] or [SHIFT]+[RESET] to update the values.
Software compatibility with respect to version V7.11:
• When updating from a version older than V7.11.
It maintains the values of the error in the positive direction of the
tables and assigns a zero error in the negative direction to all the
points.
• When changing to a version older than V7.11.
It maintains the error values in the tables in the positive direction, but
it loses the ones in the negative direction.
i
Number Parameter Update
P42 MAXFEED Beginning of the next block
P43 JOGFEED Beginning of the next block
Number Parameter Update
P161 TLOOK Beginning of the execution of a program.
MPGn MP(X-C)n MPSn
MPSSn MPASn MPLCn

Fagor CNC 8055i Specifications

General

Brand	Fagor
Model	CNC 8055i
Category	Power Tool
Language	English