33
OLED of the Fanatec® steering wheel.
• Step 5: If the wheel centre was not yet calibrated ‘CAL’ will blink on the
OLED display of the steering wheel (shown right).
▪
Proceed with a manual wheel centre calibration
as described in chapter ‘Hotkeys’ of this
manual.
▪
The Podium Racing Wheel F1® is ready to use
after manual wheel centre calibration.
• Step 6: Your Podium Racing Wheel F1® is ready to
use. If the wheel centre was previously calibrated, step
5 can be skipped and the Podium Racing Wheel F1® is ready to use
immediately. If you use a H-pattern shifter the wheel base rmware will
request to calibrate the gears automatically now. Refer to chapter ‘Shifter
calibration mode’ later in this user manual.
7.3 Tuning Menu
Activate the Tuning Menu by pressing the Tuning Menu button (see the ‘Hotkeys’
chapter of this user manual). The menu will be shown on the tuning display of
the Fanatec
®
steering wheels. To navigate through the Tuning Menu, use the
Tuning Menu button
FunkySwitch
TM
directional stick of the Fanatec
®
steering wheel.
Note: Tuning functions are subject to change and may be altered in future
rmware versions.
7.3.1 S_1 … S_5 (Setups)
Setups range: S_1 ... S_5 Setups default: S_1
The Podium Racing Wheel F1® provides ve different setups to store your
adjusted values independently from each other. To change which setup is
active, move the directional stick of the Fanatec
®
steering wheel in the up or
down direction.