Troubleshooting
17
WARNING
Trouble Probable Cause Suggested Remedy
1. Check main and branch circuit fuses or
circuit breakers.
2. Check line wire connections to fan and
switch wire connections in the switch
housings.
CAUTION: Make sure main power is
turned off !
CAUTION: Make sure main power is
turned off !
3. Replace with new battery.
1. Attach blades to fan before operating.
2. Check to make sure all screws in motor
housing are snug (not over-tight).
For your own safety turn off power at fuse box or circuit breaker before trouble shooting your fan.
1. FAN WILL NOT
START
2. FAN SOUNDS NOISY
3. FAN WOBBLES
EXCESSIVELY
5. NOT ENOUGH AIR
MOVEMENT
1. Fuse or circuit breaker blown.
2. Loose power line connections to the fan,
or loose switch wire connections in the
switch housing.
3. Dead battery in remote control.
4. Make sure reverse switch position is all the
way to one side.
4. Reverse switch in neutral position.
1. Blades not attached to fan.
1. Tighten both setscrews and nuts securely in
downrod support.
1. Setscrew and nut in downrod support is
loose.
2. Loose screws in motor housing.
2. Tighten the setscrew in the downrod/hanger
ball assembly.
2. Setscrew in downrod/hanger ball assembly
is loose.
3. Check to make sure wire connectors in
switch housing are not rattling against each
other or against the interior wall of the switch
housing.
3. Wire connectors inside housing rattling.
4. Some fan motors are sensitive to signals
from solid-state variable speed controls.
Solid-state controls are not recommended,
choose an alternative control method.
4. Motor noise caused by solid state variable
speed control.
3. Check to be sure screws which attach the
fan blade to the flywheel are tight.
3. Screws securing fan blade to motor hub
are loose.
4. Tighten the hanger bracket screws to the
outlet box and secure outlet box.
4. Hanger bracket and/or ceiling outlet box is
not securely fastened.
1. If possible, consider using a longer downrod
(notincluded, you can buy the longer downrod
fromfanimation.com).
4. REMOTE CONTROL
DOES NOT WORK.
THE CONTROL
INDICATOR LED IS
CONSTANTLY
FLASHING.
1. The battery/batteries are going to
run out.
1. Please replace the battery/batteries.
To Next Page
Loading...
