15
fantech
Low voltage control systems
* Please see instruction manuals for individual controls for proper wiring and set up of control systems.
CENTRAL CONTROLS
– These control options can only be used individually
CONTROLS FEATURES CONNECT TO
ECO-Touch
Our most complete, yet easy to use control system
Sleek design with backlight touchscreen LCD
ECO mode selects the best operating mode and speed for the
season, minimizing energy use associated with ventilation
Set preferred indoor relative humidity range and ventilation
mode for day and night conditions
No battery to replace, all programmed settings are retained
during power outage
Error code messages reduce troubleshooting time
EDF7
Recirculation and Standby
dehumidistat
When the humidity exceeds the desired setpoint, the venti-
lation system operates at Normal speed.
Once the desired humidity level is achieved, your ventilation
system resumes to its previous mode of operation
EDF1/1R Press button once for continuous Reduced speed
40 minutes OFF and repeat
• EDF1 – Press button a third time and the system will run
continuously on HIGH speed
• EDF1R – Press button a third time and the system will run
recirculation on HIGH speed
AUXILIARY CONTROL – These controls can be paired
RTS2*
Boosts system to high speed with the touch of a button
RTS3
-
ous mode on HIGH speed for 40 minutes (Yellow).
mode on HIGH speed for 60 minutes (Red).
off).
MDEH1
Rotary dial Dehumidistat
We recommend setting the relative humidity above 80%
during the summer
To avoid window condensation:
It is not necessary to change
the humidity control every
weekly temperature or
experiment with various
settings until you find a level
that is comfortable for you.
Adjust the control when
needed.
A dehumidistat is ideal for
use in energy efficient
houses where indoor
humidity (during the
heating season) is higher
than outdoor levels. High
humidity is a major cause
of structure damage and
and mildew.
between control
and HRV
(+ → + ; - → -)
EDF EDF
EDF EDF
EDF EDF
+T -T
D D
D D
To Next Page
Loading...
