IT
EN
DE
FR
MAINTENANCE
45
MAINTENANCE
INTRODUCTION
Before carrying out any maintenance or inspection on the vehicle, switch off the engine and wait for it and the exhaust
system to cool to avoid the danger of burns.
Some vehicle parts are harmful or even toxic and care must be taken when handling them.
Check that the following norms are satisfied:
– The place where the work will be carried out must be sufficiently ventilated and there must be a sufficient change of air
in the room;
– The area where the work is carried out must not be dusty, dirty or cluttered with other parts not belonging to the vehicle;
– The tools and equipment must be suitable for the type of maintenance to be carried out;
– Wear suitable clothing (work overalls), working gloves, latex gloves, protective goggles (or mask) during maintenance
that requires them;
– Have original spare parts to hand or the necessary liquids for maintenance to be carried out (such as brake pads, gear
oil, brake fluid, coolant).
Unless expressly described otherwise, reassemble units that have been disassembled by proceeding in the reverse order
to the disassembly operations. The user can normally carry out routine maintenance work, even though specific tools/
equipment and a technical preparation may sometimes be required. If you do not have all the tools or equipment for
carrying out the work, it is inadvisable to proceed by trial and error.
If it is necessary to call the service centre or to have technical advice, contract a FANTIC MOTOR Dealer.
If the user is not interested in carrying out routine maintenance, we recommend going to a FANTIC MOTOR Dealer.
In this case it is the responsibility of the user to tell the Dealer of any maintenance work already carried out so that
it is not repeated unnecessarily.
To Next Page
Loading...
