HID GLOBAL CONFIDENTIAL AND/OR PROPRIETARY INFORMATION. This document contains confidential and/or proprietary information,
which may not be duplicated, published, disseminated or disclosed, or used for any purpose, without the written consent of HID Global
Corporation. If you are an unintended recipient of this information or are unwilling to accept the above restrictions, please immediately return
this document to HID Global Corporation, 15370 Barranca Pkwy, Irvine, CA 92618-3106..
This device is electrostatically sensitive. It can be damaged if exposed to
static electricity discharges.
Information that raises potential electrostatic safety issues is indicated by a
warning symbol (as shown to the left).
To prevent equipment or media damage, refer to the following safety
messages before performing an operation preceded by this symbol.
To prevent equipment or media damage, observe all established Electrostatic
Discharge (ESD) procedures while handling cables in or near the Circuit Board
and Printhead Assemblies
To prevent equipment or media damage, always wear an appropriate personal
grounding device (e.g., a high quality wrist strap grounded to avoid potential
damage).
To prevent equipment or media damage, always remove the Ribbon and
Cards from the Printer before making any repairs, unless otherwise specified.
To prevent equipment or media damage, take jewelry off of fingers and hands,
as well as thoroughly clean hands to remove oil and debris before working on the
Printer.
To Next Page
Loading...
Need help?
General
