PERLA HP - ISSUE 02
11
FAS International S.p.A. - Via Lago di Vico, 60 - 36015 SCHIO (VI) Italy - tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
3 INSTALLATION
Installation should be carried out by skilled staff in accordance with current regulations
and manufacturer’s instructions. Installation should also comply with CEI EN 60335-1
"Safety of household and similar electrical appliances.
A faulty installation can cause damage to people, animals and things, for which the
manufacturer cannot be held responsible.
Electrical safety is guaranteed only if the machine is correctly connected to an effective
earthed system installed in compliance with current safety rules. It is necessary to verify
this essential safety condition. If in doubt ask skilled staff to control the whole system.
The manufacturer cannot be held responsible for damages caused by missing earthed
system.
The machine cannot be installed in places where the room temperature is not
comprised between 5° and 35°C, in places that are not protected by atmospheric
agents and in places where jets of water are used for cleaning.
Description of connections
1. Plug“Schuko”
2. Differential magnetothermal
switch
3. Water tap
4. Water pipe
The vending machine must be installed on a surface (floor,
intermediate floor) of suitable bearing capacity. Check that the power
of the whole electrical system is adequate for the maximum power of
the machine (see plate). The appliance must be connected to a power
supply mains featuring earthing which complies with current
legislation. The manufacturer recommends providing an electric
power supply mains for the vending machine which is equipped with a
disconnecting device having a contact opening of at least 3 mm.
Ensure that the plug is accessible after installation. It is strictly
forbidden to use extension cords, adaptors or multiple jacks.
When connecting the machine to the power supply, please take all
instruction of this booklet into account.
In order to avoid dangerous overheating it is advisable to unwind the
supply wire entirely.
Do not clog ventilation and dissipation grates.
All cleaning operations must be carried out after disconnecting power
and water supply as described for previous operations.
Once connections have been made, the vending machine must be
placed near to a wall so that its back has a minimum distance of 5 cm
from the wall in order to allow a regular ventilation (connectors are
part of the vending machine). Do not cover with clothes or similar.
The machine performs best at 10-32°C room temperature. Do not
therefore install the machine near heat sources.
3.1 DISINFECTING AND SANITIZING
During the installation stage you must proceed with the total sanitization of the complete hydraulic circuit and
of the parts in contact with the foodstuffs in order to eliminate every trace of bacteria which may have formed
during storage. Also use sanitizing products (e.g. chloro detergents) for cleaning inside the vending machine,
complying scrupulously with the doses specified on the label. Do not use detergents which are too
"aggressive" as they could damage some of the parts. The manufacturer declines all responsibility for
damage caused by the improper use of such detergents or the use of toxic agents.
To Next Page
Loading...