PERLA HP - ISSUE 02
13
FAS International S.p.A. - Via Lago di Vico, 60 - 36015 SCHIO (VI) Italy - tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
3.4 MASTER / SLAVE CONNECTION
It is possible to connect a SLAVE machine
(KRYSTAL FULLVIEW) to the MASTER machine.
Using a serial cable and the connector installed on
the back of the machine.
3.5 WARNINGS FOR THE INSTALLATION
The machine is sold without payment system. Therefore whatever default to the machine or damages to
person or things due to an incorrect installation, use or similar caused by the payment system will be only
and exclusively charged to those who have carried out the installation of the machine.
After the installation procedure is completed, never store the safety switch key inside
the vending machine. The installer must take possession of the interlock key. The
interlock key must only be consigned to qualified assistance service personnel. Once
the qualified assistance service technician has completed the required operations as
described in this manual he must always remove the key from the vending machine, in
order to prevent the loader from using it.
3.6 INACTIVITY
If long periods of machine inactivity are expected, it is recommended to adopt adequate precautions to
prevent dangerous situations when the machine is re-started.
For long resting period, it is necessary:
• To empty out the hydraulic circuit completely;
• To empty out all the products from the canisters;
• To empty out the coffee grinder-metering unit;
• To clean the machine thoroughly and to dry it;
• To check carefully for damaged or worn parts and to replace them;
• To check that the screws and bolts are securely tightened;
• To cover the machine after having stored it in a protected environment.
To re-set the machine at work, comply with the instructions given in the paragraph “Installation” of this
manual and pay particular attention if food products are to be sold (see paragraph “INSTALLATION”).
3.7 WARNINGS FOR THE DEMOLITION OF THE MACHINE
If the machine is disassembled in order to be definitively demolished, it is obligatory
to follow the rules in force regarding the protection of the environment.
All ferrous, plastic or similar materials should be taken to the authorized depots.
Disposal in compliance with EU 2002/96/EC standards, according to the
implementation of the Directive into the national law.
This equipment complies with Directive 2002/95/EC (RoHS).
Should you have any queries, you are recommended to contact competent local refuse disposal authorities.
To Next Page
Loading...