PERLA HP - ISSUE 02
43
FAS International S.p.A. - Via Lago di Vico, 60 - 36015 SCHIO (VI) Italy - tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
10.2.5 SETTING THE CLOCK AND DAILY TIMERS
Alarm set 01 Sets the year/month/day:
This command is used to set the year, month and day on the clock in the control board. The introduction
format is YYMMDD.
Alarm set 02 Sets the hour and minute:
This command is for setting the hour and minute in the realtime clock built into the electronic control board.
Key in the exact time in hours and minutes and press the ENTER pushbutton to confirm the setting.
Next the system asks if you wish the time to appear on the display. If 1 = time display enabled, if 0 = time
display disabled.
Alarms 11–14 Lights on/off: (only slave machine)
With these commands two daily periods can be programmed for switching the lighting on and off. However,
even in the periods when the lighting is programmed off, simply pressing a button on the keyboard or
inserting money will activate the lighting for a period of 3' for the vend cycle to take place. To disable this
time command simply program value 24 in command 11.
If, for example, you wish to activate the lighting from 11 to 12 and from 13 to 14, proceed as follows:
1. Programming mode, the following appears on the display ......................................................Command 00
2. Type 02 and press ENTER, the following appears on the display................................................ Alarms 00
3. Type 11 and press ENTER, the first lights ON time appears on the display ....................................... NNNN
4. Set value 1100 and press ENTER.
5. Type 12 and press ENTER, the first lights OFF time appears on the display...................................... NNNN
6. Set value 1200 and press ENTER.
7. Type 13 and press ENTER, the second lights ON time appears on the display ................................ NNNN
8. Set value 1300 and press ENTER.
9. Type 14 and press ENTER, the second lights OFF time appears on the display................................ NNNN
10. Set value 1400 and press ENTER.
N.B.: The periods must be programmed in the sequence 11-12-13-14.
If this function is not required, program 2400 in Alarm 11.
Alarms 21–24 Setting the discount time slots :
These commands are used to set the discount sales time slots throughout the day. In the time slots when
the discounts are activated the machine refers to the prices set in the discount prices submenu. Naturally,
command 62 in the main menu must be set at 1.
For example, to set a discount period lasting from 10.30 to 13.30, proceed as follows:
1. Go into programming mode to display ..................................................................................._Command 00_
2. Key in 02 and press button ENTER to display ........................................................................ _Alarm set 00_
3. Key in 21 and press button ENTER to display the time when discounted prices are first activated. _NNNN_
4. Set value to 1030 and press button ENTER.
5. Key in 22 and press button ENTER to display the time when discounted prices are first deactivated_NNNN_
6. Set value to 1330 and press button ENTER,
N.B.: The periods must be programmed in the following order: 21-22-23-24.
If use of this function is not required, programme 2400 at Alarm 21
.
To Next Page
Loading...