38 PERLA HP - ISSUE 02
FAS International S.p.A. - Via Lago di Vico, 60 - 36015 SCHIO (VI) Italy - tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
Command 64 Sets the message display language:
This command controls the language in which the messages are displayed. Value 0 corresponds to Italian,
value 1 to English, value 2 to French, value 3 to German, value 4 to Dutch, value 5 to Swedish, value 6 to
Finnish and value 7 to Spanish 8 to Portuguese 9 to Danish 10 to Norwegian.
Command 67 Display of slave temperature :
When this command is set at 1, the internal temperatures of slave machine which may be connected to this
one appear on the display.
Command 68 Setting displayed currency description :
The command allows the operator to set the desired currency. 4 characters are available and they are
entered using the same method as described for Command 95.
Command 69 Chooses functioning mode of the coin mechanism:
This command chooses the type and mode of functioning of the coin mechanism. The parameter can
assume the following values:
0 System EXECUTIVE with prices controlled in the machine (see relevant paragraph).
1 System EXECUTIVE in PRICE HOLDING mode (i.e. prices programmed in the coin mechanism). In
this case, the prices programmed at command 03 and those programmed in the coin mechanism
must be the same (see relevant paragraph). Alternatively you can set the “Price-Display” parameter.
If enabled, the vending machine will utilize exclusively the information on the price value deriving
from the payment system, that is, it will not be necessary to fill in the price tables (Commands 03 and
04); simply set only Command 05 (see relevant paragraph).
4 System BDV 001 (see paragraph using the coin mechanism BDV)
5 Payment system MDB (see paragraph on using the MDB payment system).
Every time this value is altered, the vending machine must be turned off for a few
seconds. By switching it on again the machine and the coin mechanism will communicate
Command 70 Buzzer operation option:
By setting this command at zero the buzzer is disconnected during machine operation.
Command 80 Cloning:
This command makes it possible to transfer all the parameters of the vending machine to a "Program Key",
to program same model machines (see also Command 50). When you enter the command "Write Clone
Key" appears on the display. Then, enter the "Program Key" and press the ENTER key. "Data Writing…*"
appears on the screen while the data is being transferred to the key. Once the data transfer operation is
completed, the machine returns to the programming mode.
Caution: DO NOT enter the key before entering the programming mode, otherwise the vending machine will
fetch the data existing in the key.
Command 81 Fetch vend data:
This command makes it possible to transfer all the EVA-DTS data to a "Program Key". This data can be
extracted using special software (VMC configurator). The maximum number of possible registrations is 100.
Attention: if the key is not recognised as a data key, at the first registration the user will be asked to confirm
the complete deletion of the existing data.
Command 85 Displaying checksums and board versions of the vending machine:
When the command opens the following text appears:
VMC board cks:xxxx Ver:x.xx
Press any button and the following appears:
Main Keyboard cks:xxxx Ver:x.xx
If a slave machine is connected, press any button and the following appears:
Slave A Keyboard cks:xxxx Ver:x.xx
Press any button and the following appears:
Chain A cks:xxxx Ver:x.xx
To Next Page
Loading...