Fastech Ezi-SPEED ESD-30-C - Page 62

-62-
Checks whether a signal is output.
Setting
Rotation speed
Sets the motor rotation speed using the setting button.
7.4.3
Sets the motor rotation speed in the operatation data.
7.5.2
Acceleration time,
Deceleration time
Sets using acceleration/deceleration time parameter.
8.6
Sets the acceleration/deceleration time in the operation data..
7.5.2
Setting of torque limit
Sets the torque limit.
7.5.2
Sets the torque limiting the operation data.
Limting the setting
range of the rotation
speed
Sets the upper limit and lower limit of the rotation speed.
8.9
Operating using
I/O signals inputs
Operates by inputting signals externally.
7.3.4, 7.5
Disables an operation with the setting button on the front panel.
8.4
Operates with multiple speeds (up to 8 speeds)
7.5.2, 8.5
Lock fuction
Disables an operation with the setting button so that the set data can
not be changed.
8.8
Changing the fuction for
I/O signals
Changes the fuctions assigned to the input signals (5 input signals).
7.3.4
Changes the fuctions assigned to the output signals (3 input signals).
Initial display at power
ON
Changes the display item when turning on the power.
8.3
Data initialization
Restores the parameter to the factory setting (initial value).
8.3
Restores the operation data to the factory setting (initial value).
8.3