-90-
12. Reference
12.1 CE marking
Ezi-SPEED is implemented the CE marking under Low Voltage Directive and EMC Directive. The
part number of the certification product is motor part number and drive part number.
• Low Voltage Directive
- This product cannot be used with cable normally used for IT equipment.
- Do not touch the hands after installing the product
- Be sure to ground the protective earth terminal of the motor and drive
- Motor cable and power supply cable should be separated by double insulation.
- Applicable Standard
• Motor : EN 60034-1:2004
• Driver : EN 61800-5-1:2007
• EMC Directive
The EMC Directive will vary depending on the control system equipment used with the other
control system equipment, configuration of electrical parts, wiring, layout, hazard level, and the
like. You must be verified through conducting EMC measures on your mechanical equipment.
- Applicable Standard
Conduction noise, Radiated noise, Noise power,
Antenna terminal voltage, High frequency
output terminal voltage, Harmonic, Flicker
EN 61800-3:2004 + A1:2012
EN 61000-3-2:2014
EN 61000-3-3:2013
Electrostatic Discharge Immunity ,
Radiated RF-Electromagnetic Field Immunity , Electrical
Fast Transient / Burst Immunity , Surge Immunity
Conducted RF Field Immunity
Power-Frequency Magnetic Field Immunity , Voltage
Dips, Short Interruptions and Voltage variation Immunity
• Toxic substance
Ezi-SPEED does not contain toxic substances exceeding the limits of the RoHS Directive.