EN-53
| evation
• Lit yellow = "Soft Fault"
If a "Soft Fault" occurs, the status display is lit yellow. In this way,
the drive system indicates that there is a temporary or non-critical
fault that in most cases will result in reduced performance.
If a "Soft Fault" occurs, you will be able to continue riding your
e-bike, but Fazua strongly recommends not doing so to avoid
further faults or damage to the drive system or to the e-bike.
• Lit red = "Hard Fault"
If a "Hard Fault" occurs, the status display is lit red. If a "Hard
Fault" occurs on your e-bike, the e-bike can no longer be used and
requires maintenance.
22.2 Display of charge level/support level
The charge level/support level display shows two parameters.
• The display for the charge level of the battery:
The charge level of the battery can be read off via the number of
lit LEDs. Each of the 10 LEDs here represents 10 % of the total
charging capacity. When the battery is fully charged, all 10 LEDs
light up. If the battery is flat, no LEDs light up.
• The selected pedal support level:
Each support level is assigned a colour, i.e. You can read off the
support level currently set via the colour of the lit LEDs on the
display.
More detailed information can be found → in chapter 23.3 "Support levels".
FAZUA Benutzerhandbuch_EN.indb 53FAZUA Benutzerhandbuch_EN.indb 53 26-Feb-20 12:47:1726-Feb-20 12:47:17
To Next Page
Loading...