Felder FB 540 - Machine Operation; Cutting Round and Thin Workpieces; Workpiece Cutting on Upright Edge

22
!
Bandsaw
FB 540/640/740/840/940
Use an appropriate device with the minimum measure-
ments as depicted in Fig. 12 to avoid the workpiece twist-
ing during the cutting process.
Fig. 11: Cutting a circular workpiece
Use a push stick as depicted in Fig. 13 to prevent your
hands from coming too close to the saw blade.
Fig. 12: Push stick
7.3.2 Cutting round workpieces in the transverse direction
7.3.3 Longitudinal cut of narrow or thin workpieces with the longitudinal guide fence
Use an auxiliary fence with the minimum measurements
to guide the workpiece safely.
Fig. 13: Auxiliary fence
7.3.4 Cutting workpieces on the upright edge
!Push stick
Operation