Felder FB 710 - Cutting Round Workpieces in the Transverse Direction; Longitudinal Cut of Narrow or Thin Work-Pieces; Cutting Workpieces on the Upright Edge

26
BN
BM
Bandsaw
FB 510/610/710 & FB 710 c-tech
Use an appropriate device with the minimum measure-
ments as depicted in Fig. to avoid the workpiece twisting
during the cutting process.
Fig. 7-9: Cutting a circular workpiece
Use a push stick as depicted in Fig. to prevent your
hands from coming too close to the saw blade.
Fig. 7-10: Push Stick
7.7.2 Cutting round workpieces in the transverse direction
Use an auxiliary fence with the minimum measurements
to guide the workpiece safely.
Fig. 7-11: Auxiliary fence
7.7.4 Cutting workpieces on the upright edge
BNPush Stick
7.7.3 Longitudinal cut of narrow or thin work-pieces
Operation