Felder FB 710 - 7.7.8 Tilting the table; 7.8 Cutting speed (c-tech)

28
212TOF
(400060-834)
!
"
#
$
! " §
Bandsaw
FB 510/610/710 & FB 710 c-tech
7.7.8 Tilting the table
Fig. 7-15: Positioning
The machine working table can be tilted up to an angle
from -5° (FB 500: -10°) up to +45°.
Adjusting the angle:
To tilt, remove the table padding to enable the saw belt
to move through the table unimpeded. Open the clam-
ping screw with the supplied spanner and tilt the table to
the desired angle, which is displayed on the mitre scale.
Tighten the clamping screw again.
Positioning -5° or -10°:
• Swing away the stop
• Adjusting the angle
To tilt the table back to its normal position, loosen the
clamping screw once again and tilt the table up to the
stop in the 0° position and clamp it in that position.
(Swing back the stop)
!Work bench
"Clamping screws
#Lever
$Fence - 0°
Operation
7.8 Cutting speed (c-tech)
Variable cutting speed of 400 - 1400 m/min
Increase or decrease the speed in steps using the
arrow keys:
• Touch control input mode: ± 50 m/min
• press and hold: ±100 m/min
Press ENTER to confirm the value.
The speed can also be altered whilst the machine is in
operation
!Move the arrow UP
"Move the arrow DOWN
#Enter key
Fig. 7-16: Set the speed (c-tech)