Fender Cyber-Twin - Program Changes and System Exclusive; Appendix 2: MIDI Program Changes

  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
+,"#,!
53
*+,+-*-. *+,*//. 0+3 *102 460+1.
Knob movements can be recorded (as continuous controller data), then
replayed for performance sequences. When the you select a MIDI
Transmit channel (1-16), the following parameters will be transmitted
(range 0 - 127):
The Cyber-Twin also will transmit program changes. The following table
shows the bank associated with each group of presets.

F
ENDER
C
USTOM
S
HOP
Bank #01: C00 – C84

P
LAYER
’
S
L
OUNGE
Bank #02: P00 – P84

Y
OUR
A
MP
C
OLLECTION
Bank #03: A00 – A34
[
[[
[
Example screens show default
Values
*+,+-*-. *+,*// 46*
When set to ON, the continuous controller information received will be
redirected (echoed) back out the MIDI Out Jack. If OFF is selected, the
only continuous controller information sent out will be new data
transmitted from the turning of a knob or operation the analog expression
pedal. This feature will aid in recording continuous controller sequences.
 ., 077+1
Any MIDI program changes contained in bank #00 can be mapped to any
preset on the Cyber-Twin. Two of the FX knobs are used to select the
values in this menu. The FX LEVEL knob selects MIDI program change
numbers 0 - 127 and FX VAL2 selects the target preset for control. Only
MIDI program changes in bank #00 will access the MIDI Preset map.
parameter CC# parameter CC#
Gain 102 FX Level 110
Volume 103 FX Val 1 111
Treble 104 FX Val 2 112
Middle 105 FX Val 3 113
Bass 106 FX Val 4 114
Presence 107 Reverb In [Dwell] 115
Reverb 108 Reverb Tone [Shape] 116
Master 109 Reverb Time 117
Reverb Diffusion 118