Contents and general instructions
V
Festo P.BE−CPX−CEC−E N en 0907NH
Designated use
The type CPX−CEC−C1 CoDeSys−Controller documented in this
manual is intended exclusively for use in Festo CPX terminals
for installation in a machine or an automation control system.
In combination with a CPX terminal, the CPX−CEC−C1 is used for
controlling pneumatic and electric actuators (valves,
output modules and motor controllers via CANopen)
interrogating electric sensor
signals through the input
modules
communication via Ethernet.
The CPX terminal with the CPX−CEC−C1 may only be used as
follows:
as designated in industrial applications
without any modifications by the user. Only the conver
sions or modifications described in the documentation
supplied with the product are permitted
in faultless technical condition
only in combination with
approved components
(e.g.valves, drive/displacement encoder combinations).
The limit values specified for pressures, temperatures,
electrical data, torques etc. should be observed.
Please comply with the regulations of the workers’ com
pensation insurance association, the German Technical
Control Board (TÜV) and the electrical requirements of the
VDE or the corresponding national and local safety regula
tions.
To Next Page
Loading...
Need help?
General
