FIBARO RGBW CONTROLLER 2 User Manual

14
operatIng tHe DevIce
• 3 red blinks – entering the menu (not added to a Z-Wave
network)
• Green – reset energy consumption memory
• Magenta – start range test
• Yellow – reset to factory defaults
7.3: Menu
Menu allows to perform Z-Wave network actions. In order to
use the menu:
1. Press and hold the button to enter the menu, device blinks
to signal adding status (see 7.2: Visual indications).
2. Release the button when device signals desired position with
colour:
• GREEN - reset energy consumption memory
• MAGENTA - start range test
• YELLOW - reset to factory defaults
3. Quickly click the button to conrm.
7.4: Resetting to factory defaults
Reset procedure allows to restore the device back to its factory
settings, which means all information about the Z-Wave control-
ler and user conguration will be deleted.
i
Resetting the device is not the recommended
way of removing the device from the Z-Wave net-
work. Use reset procedure only if the primary control-
ler is missing or inoperable. Certain device removal
can be achieved by the procedure of removing
described.
1. Press and hold the button to enter the menu.
2. Release button when the device glows yellow.
3. Quickly click the button to conrm.
4. After few seconds the device will be restarted, which is
signalled with the red colour.

FIBARO RGBW CONTROLLER 2 Specifications

General

Brand	FIBARO
Model	RGBW CONTROLLER 2
Category	Controller
Language	English