2
Important safety information
Read this manual before attempting to install the device!
Failure to observe recommendations included in this manual
may be dangerous or cause a violation of the law. The manufacturer,
Fibar Group S.A. will not be held responsible for any loss or damage
resulting from not following the instructions of operating manual.
!
Danger of electrocution!
FIBARO Roller Shutter 3 is designed to operate in electrical
home installation. Faulty connection or use may result in re or elec-
tric shock.
All works on the device may be performed only by a qualied and
licensed electrician. Observe national regulations.
Even when the device is turned o, voltage may be present at its ter-
minals. Any maintenance introducing changes into the conguration
of connections or the load must be always performed with disabled
fuse.
Caution
It is not recommended to operate all of the roller blinds simul-
taneously. For safety reasons, at least one roller blind should be con-
trolled independently, providing safe escape route in case of emer-
gency.
!
To Next Page
Loading...