EasyManua.ls Logo

Fibocom L831-EAU-01 - Antenna Design

Fibocom L831-EAU-01
39 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Reproduction forbidden without Fibocom Wireless Inc. written authorization - All Rights Reserved.
L831-EAU-01 Hardware User Manual Page
34
of
39
Description
Condition
Test Result
GLONASS
Cold Start
30s / -130dBm
Warm Start
28s / -130dBm
Hot Start
1s / -130dBm
Sensitivity
GPS
Acquisition
-146dBm
Tracking
-160dBm
GLONASS
Acquisition
-143dBm
Tracking
-159dBm
Note:
The GNSS current is measured under RF disabled condition.
4.6 Antenna Design
The L831-EAU module provides main and diversity antenna interfaces, and the antenna design
requirements as shown in the following table:
L831-EAU module Main antenna requirements
Frequency range
The most proper antenna to adapt the frequencies should be used.
Bandwidth (WCDMA)
WCDMA band I(2100) : 250 MHz
WCDMA band VIII(900) : 80 MHz
Bandwidth (LTE)
LTE band 1(2100): 250 MHz
LTE Band 3(1800): 170 MHz
LTE band 7(2600): 190 MHz
LTE Band 8(900): 80 MHz
LTE band 20(800): 71 MHz
LTE Band 28(750): 100 MHz
Impedance
50 Ohm
Input power
> 25dBm average power WCDMA & LTE
Recommended
standing-wave ratio
(SWR)
2:1

Related product manuals