EN
99
7.5.6.3 COUNTRY STANDARD
By accessing to the Country Standard sub-menu you can modify
the grid standard within 24 hours while the inverter is operating.
NOTE – D After the grid standard is set you have 24 hours
to make any changes to the grid standard value; 24 hours
later the Country Standard sub-menu will be locked, and any
subsequent changes might only be made accessing with
Admin Plus privileges. Refer to the dedicated section on
“USER menu” and “SERVICE TOOLS menu” to know how to
unlock the Country Standard sub-menu.
7.5.6.4 DATE AND TIME
In the Date and Time sub-menu it’s possible to sets the date, time
and time zone.
The inverter will propose these fields when the time protocol is
available.
When it’s not possible for the inverter to detect the time protocol,
these fields have to be manually entered.
7.5.6.5 RESET MANUFACTURING (Only visible and
editable with Admin Plus privileges)
In the Reset Manufacturing sub-menu it’s possible to factory
reset the settings related to country standard and related to
communication parameters:
• Reset Country Std and Restore Default: Reset country standard
and restore communication parameters to default. The inverter
connectivity will be reboot after the operation.
• Reset Country Standard: Reset ONLY country standard. The
inverter connectivity will be reboot after the operation.
• Reset to Default: Reset ONLY communication parameters (not
country standard). The inverter connectivity will be reboot after
the operation.
• Connectivity Reboot: Reboot of the inverter connectivity.
7.5.7 INFORMATION menu
In the INFORMATION Section it’s possible to view the general
information about the Web User Interface.
it’s possible to access the following sub-menus:
PRODUCT INFO
PRIVACY POLICY
PROVIDER INFORMATION/IMPRESSUM
ACKNOWLEDGMENTS
RELEASE NOTES
To Next Page
Loading...
