168
000039DG-F
8 - Maintenance
Storage and dismantling
Storage of the equipment or prolonged stop
If the equipment is not used immediately or is stored for long periods,
check that it is correctly packed and contact FIMER for storage instruc
-
tions.
The equipment must be stored in well-ventilated indoor areas having no
characteristics that could damage the components of the equipment.
Restarting after a long or prolonged stop requires a check and, in some
cases, the removal of oxidation and dust that will also have settled inside
the equipment if not suitably protected.
Dismantling, decommissioning and disposal
FIMER is not responsible for any loss of the equipment, or part of it,
which does not take place on the basis of the regulations and laws in
force in the country of installation.
The symbol of the cancelled bin (where present) indicates that the product must not be dispo-
sed of with domestic waste at the end of its useful life.
This product must be delivered to the waste collection point of the local community for
recycling.
For further information, refer to the public body responsible for waste disposal in the country.
Inappropriate disposal of waste can have a negative impact on the envi-
ronment and human health owing to potentially dangerous substances.
By cooperating in the correct disposal of this product, you contribute to
the reuse, recycling and recovery of the product, and the protection of
our environment.
Dispose of the various types of materials that the parts of the equipment consist of in dumps
that are suitable for the purpose.
COMPONENT MATERIAL OF CONSTRUCTION
Frame, brackets, supports Arc-welded steel FE37, aluminium
Casing or covers ABS, plastic
Paint RAL
Gaskets and seals Rubber / Teon / Viton
Electrical cables Copper / Rubber
Cable trays Polyethylene / Nylon
Batteries Nickel / Lead/ Lithium
To Next Page
Loading...