Fimer SYMPLEX 320 - Page 4

APPLICATIONS
STANDARD MIG/MAG WELDING
Arc welding by using a wired electrode where both arc and welding pool are protected from atmosphere
thanks to a shielding gas protection provided by an external source.
FLUX CORED WIRE MIG/MAG WELDING
Welding by ux cored wires is about a metallic coating and a soul made of powders. As per standard MIG/
MAG welding, the arc is protected from atmosphere by a shielding gas.
NO-GAS FLUX CORED WIRE MIG/MAG WELDING
Welding by ux cored wires is about a metallic coating and a core made of powders. Otherwise of standard
MIG/MAG welding, the arc is self protected from the powders contained in the core and it is always used a
continuous current with direct polarity (torch connected to negative pole “-“).
ELECTRODE/MMA MANUAL WELDING
MMA welding uses the electric arc generated between consumable electrode and fusion pool. It doesn’t use
any protection gas, in fact the atmosphere protection comes from the electrode.
GOUGING
The gouging uses the arc creation between a consumable electrode made by carbon/graphite and liquid
fusion pool which is expelled by a jet of compressed air; usually used to remove welding; pay attention to
special torches use.
SYMPLEX 320
5T5.321.152
MIG-MAG / MMA 3PH
15 - 320 A (MIG-MAG)
15 - 300 A (MMA)
Peso
19.8 kg
SYMPLEX 420
5T5.421.152
MIG-MAG / MMA 3PH
15 - 400 A (MIG-MAG)
15 - 370 A (MMA)
Peso
21.3 kg