EasyManua.ls Logo

FireAngel SO-601 - APPLICATION

FireAngel SO-601
34 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
APPLICATION
WARNING: Your FireAngel smoke
alarm can be installed into a new
build property as additional protection to
an existing smoke detection system only. It
cannot be used as a substitute for a hard wired
system as required in new build properties. In
this type of property the building regulations
require alarms to be interlinked. You can
obtain further information from your local re
service or building control department at your
local council ofces. These sources generally
provide advice on new builds or projects that
require planning permission.
Your smoke alarm typically meets the minimum
requirements for family living units in existing
buildings, as long as at least one unit is installed on
each oor/level of your property.
In order to achieve the earliest re warning, we
recommend that a smoke alarm is tted in all rooms
where the temperature is normally between 4°C
(40°F) and 38°C (100°F). The type of smoke alarm
used in each location should be appropriate to the
environment. Check the section on ‘Positioning’ to
ensure that the smoke alarm is to be correctly
positioned for the particular dwelling into which it
is intended to be installed.
WARNING: The alarm positions
shown overleaf are based on typical
homes. Construction and layout of individual
dwellings will vary, so this should be regarded
only as a guide. Check with your local re
station for further guidance.

Related product manuals