FireClass FC506 - Communication Menu; Panel Language Menu

9
Communication menu
In the communication menu, you can choose the
connection mode between the panel and your computer;
the options include TCP/IP, RS232 or USB.
Click on the refresh icon to update the type of connection.
Click the TEST button to verify the functionality of the
connection status. The FireClass FC500
(FC501_FC503_FC506) Console will show a pop-up that
asks you to enter an installer password every time you
want to read or write to or from the panel. The password
you enter should match with the panel installer password
for successful communication. In the TCP/IP mode, you
must enter the FC500IP parameters and Encryption key.
Use the IP module to program the parameters
corresponding to the IP module described below.
Figure 7: Entering the installer password
IP address
Enter the IP address assigned to the IP module you want
to program or, if dynamic IP address (DHCP) is selected,
contact the network administrator to request the IP
address details assigned to the IP module.
Dynamic DNS service
Control and monitor the panel remotely using ethernet, a
dynamic DNS service. You can use graphic maps without
a static IP address assigned by an internet provider to the
supervisor site. Add the necessary fields to the
configuration software in the FireClass software. This
allows you to connect to the control panel remotely using a
fixed literal domain name; for example,
mysupervisedsite.dns.org. You can avail of this site
instead of a numeric IP address. The default setting is
192.168.0.101.
IP module port
Enter the details of the port assigned to the IP module you
want to program. Contact the network administrator for
this.
IP module code
Enter the access code assigned to the IP module you wish
to program. The default setting is 5555.
Encryption key
Enter the encryption key assigned to the IP module you
want to program. The default setting is 32 zeros.
Panel language menu
The panel language menu allows you to change the
system language on the user interface or repeater to any
of the languages currently loaded. Follow the steps below:
1. In the Loaded Language section, select Change
System Language.
2. Select the language and the device, user interface
or repeater.
3. Override the language in the control panel
memory.
4. When the new language download finishes, the
panel uses the language and updates any
necessary peripherals.