FireClass Panels and Repeaters Installing the PNI800 - Panel Net Interface
Installation Guide Doc. version 2.0 34
Item Function
J1 See Table 17.
SW1 See Table 18, 19, 20, and
21.
SW2 See Table 22, 23, 24, and
24.
SW3 See Table 26 and 27.
SW4 See Table 28.
DIP switch (Internal
N-BUS address)
SW5 Reset button
XT1 FC NET connector
XP1 Backplane (Internal N-
BUS) connector
XP2 Auxiliary Zonal LED panel
connector (e.g. for
PNI800 in box)
XP3 Debug Port (RS232)
connector
XP4 Auxiliary power supply
connector (e.g. for
PNI800 in box)
XP5 Left fibre optic module
XP6 Right fibre optic module
XP7 Auxiliary JTAG port for
CPU
XP8 Auxiliary JTAG port for
CPLD
Table 16: PNI800 - Jumper, switch and terminal functions
Jumper 1-2 2-3
J1Bypass Normal Mode*
Node Bypassed
[2]
Table 17: PNI800 - J1 jumper setting
* Default.
[2] The FC-Network left and right channels are hardware-con-
nected. Set this only if the PNI800 card is non-operational
(due to a fault or not being powered up for example).
SW1 Position Application
1 2
OFF OFF Gateway*
ON OFF Bridge
ON ON Hub
OFF ON Reserved
Table 18: PNI800 - Application setting
*Default
SW1 Position Network Baud Rate
3 4 5
ON ON ON 9600
OFF ON ON 19200
ON OFF ON 38400
OFF OFF ON 57600
ON ON OFF 76800
OFF ON OFF 115200*
ON OFF OFF Reserved
OFF OFF OFF Reserved
Table 19: PNI800 - Network baud-rate setting
* Default.
SW1 Network Topology
Position 6
ON BUS
OFF RING*
Table 20: PNI800 - Network Topology setting
* Default.
SW1 MAIN MCU FW
Position 8 upgrade mode
ON Enabled. Mode is
activated after RESET
OFF Disabled*
Table 21: PNI800- Main MCU FW upgrade mode enable
*Default
SW2 Host Interface
Position 1
ON RS232
OFF NBUS*
Table 22: PNI800 - Host Interface setting
* Default.
SW2 Emergency Display
Position 2
ON Enabled
OFF Disabled*
Table 23: PNI800 - Emergency Display setting
* Default.
To Next Page
Loading...
