FireClass Panels and Repeaters Optional mounting plate
Installation Guide Doc. version 2.0 6
BAQ140T24 PSU for 17AH batteries. The FC604S
Scandinavian is a networkable panel.
4.1 Optional mounting plate
The FC600 series panels are not supplied with a mount-
ing plate. Mounting plates are available to
purchase using part number 557.202.921. They can be
used with all panels except for DC Repeaters. See Fig-
ures 2 and 3.
4.2 Mounting a FC600 series
panel to the wall without a
mounting plate
For an overview of the panel, see Fig. 4. To mount a
FC600 series panel without the optional mounting plate,
complete these steps:
1 Decide on a wall mounting method (typically screws
into rawl plugs), and assess the required sizes of the
fastenings. Take into account the type of wall (solid
brick, wood and so on), and the weight of the assem-
bled control panel housing.
2 For the upper mounting holes, mark on the wall the
drill hole positions. Drill and plug the holes.
3 Insert screws to suspend the housing from the
upper holes. The housing may feature “keyholes” to
allow you to insert the screws into the bare wall,
then drop the housing onto the screws (rather than
screwing with the housing in position, through the
back wall.
4 Ensure the housing is horizontal. For the lower
mounting holes, mark on the wall the drill hole posi-
tions. Drill and plug the bottom fixing holes. Insert
screws to complete fixing the housing to the wall.
5 Check the housing is physically secure.
6 Remove any debris from the housing.
Fig. 2: Optional mounting plate 557.202.921, available to
purchase.
To Next Page
Loading...
