16 User Manual Doc. version 2.0
3.1 Access levels FireClass Panels and Repeaters
2 – Point I/P Only 22 User 1 (ON)
3 – Point O/P Only 22 User 1 (ON)
4 – By Function 22 User 1 (ON)
5 – By Loop 23 Engineer 1 (ON)
9 – Non-LED Outputs 23 Engineer 1 (ON)
4 – By Loop 23 User 1 (ON)
1 – Set Time/Date 23 User 1 (ON)
2 – Summer/Winter 23 User 1 (ON)
5 – Event Log 23 User 1 (ON)
1 – View Event Log 23 User 1 (ON)
2 – Print Event Log 24 User 1 (ON)
3 – Filter 24 User 1 (ON)
6 – View/Print Data 24 User 1 (ON)
1 – Points Disabled 24 User 1 (ON)
2 – Test Results 24 User 1 (ON)
1 – Pts Unt./Failed 24 User 1 (ON)
2 – Self Test O/P 24 User 1 (ON)
3 – Point Values 24 User 1 (ON)
4 – View Faults 25 User 1 (ON)
5 – Loop Info (Information) 25 User 1 (ON)
6 – Forced Points 25 Engineer 1 (ON)
7 – Active Points 25 Supervisor 1 (ON)
8 – By Function 25 User 1 (ON)
1 – Fire inputs 25 User 1 (ON)
2 – Non-fire inputs 25 User
1 (ON)
3 – All Loop O/Ps 25 User 1 (ON)
4 – Sounders 25 User 1 (ON)
5 – Protection Eqp. 25 User 1 (ON)
6 – Plant equipment 25 User 1 (ON)
9 – Device Dates 25 Engineer 1 (ON)
7 – Service 25 Supervisor 1 (ON)
1 – Walk Test 26 Supervisor 1 (ON)
2 – Maintenance 27 Engineer 1 (ON)
1 – Counters 27 Engineer 1 (ON)
3 – Maintenance Request 27 Engineer 1 (ON)
4 – Battery Test 27 Engineer 1 (ON)
6 – Project Numbers 27 Engineer 1 (ON)
7 – Software Versions 27 Engineer 1 (ON)
Function See Page Login Level Enable Key
Table 4: Functions and required access levels (cont.)
*This function is not available in all countries or panel versions.
To Next Page
Loading...
