FireClass FC600 - 3 Functions; Access Levels

FireClass Panels and Repeaters 3 Functions
User Manual Doc. version 2.0 15
3 Functions
The control panel functions allow you to view the event
log and set the date and time.
3.1 Access levels
To access most of the functions you need to log on to
the panel, using your user ID and passcode. See section
3.1.1 “Logging on” on page 17. Each user ID has an
assigned access level to the functions.
The access levels are as follows:
All EN54-2 access level 4 functions are available from
the Express (PC Tool).
Table 4 shows the minimum access level required to
use each function.
Login Level EN54-Access Level
Enable Key OFF/No Logon 1
User 2
Supervisor 3
Engineer 4
Express (PC Tool) 4
Table 3: Access levels
Function See Page Login Level Enable Key
Press SILENCE BUZZER* control key 7 No logon needed 0 (OFF)
Press View menu (F1) key
Contains the same items as View/Print Data
> By Function, and Test Buzzer LEDs & Dis-
play
No logon needed 0 (OFF)
Press DAY/NIGHT* control key 8 No logon needed 1 (ON)
Press Not Clr* (F4) key 9 No logon needed 0 (OFF)
Press SILENCE/RESOUND key 12 No logon needed 1 (ON)
Press RESET key 14 No logon needed 1 (ON)
Press INVESTIGATE* control key 8 No logon needed 1 (ON)
Press TEST* control key 14 No logon needed 1 (ON)
Press EVACUATE* control key 12 No logon needed 1 (ON)
Main Menu 19 No logon needed 1 (ON)
1 – Accept Events* 20 User 1 (ON)
2 – View Status 20 No logon needed 1 (ON)
1 – Full Point 20 User 1 (ON)
2 – Point I/P only 20 User 1 (ON)
3 – Point O/P only 21 User 1 (ON)
4 – Zone 21 User 1 (ON)
5 – Zone Maps 21 User 1 (ON)
6 – Network Status 21 User 1 (ON)
7 – Comis. O/View 21 User 1 (ON)
3 – Disablements 21 User 1 (ON)
1 – Full Point 22 User 1 (ON)
Table 4: Functions and required access levels
*This function is not available in all countries or panel versions.