FireClass Panels and Repeaters 3.1 Access levels
User Manual Doc. version 2.0 17
3.1.1 Logging on
Log on to the panel to access most of the control panel
functions.
Logging on to the panel
1 Turn the Enable keyswitch clock-wise to the 1 (ON)
position.
Note: For Swedish marketplaces, login with the key
by turning it clock-wise according to SS 3654.
2 Press the Passcode (F3) key.
3 Enter your user ID. You only need to press the Enter
(F5) key if your ID has only one digit.
If you are already logged on, you see an open mes-
sage. Press the Back (F1) key.
4 Enter your passcode. You only need to press Enter
(F5) if your passcode has less than six digits.
If another user was logged on, this user is automat-
ically logged off.
3 – Diagnostics 27 Engineer 1 (ON)
1 – Force Point 27 Engineer 1 (ON)
3 – Shutdown/Rstart 28 Engineer 1 (ON)
4 – Point Log 28 Engineer 1 (ON)
5 – Poll Addr 255 28 Engineer 1 (ON)
6 – Single Dev.Poll 28 Engineer 1 (ON)
7 – Change Address 28 Engineer 1 (ON)
8 – Net. Card Info 28 Engineer 1 (ON)
9 – IP Net Setting 29 Engineer 1 (ON)
4 – Calibrate DDM 29 Engineer 1 (ON)
5 – Restart Systems 29 Engineer 1 (ON)
6 – Switches 29 Engineer 1 (ON)
1 – Fast Fault Mode 29 Engineer 1 (ON)
2 – Rate of Rise 29 Engineer 1 (ON)
5 – Detect Power Up 29 Engineer 1 (ON)
6 – RSM Test mode 30 Engineer 1 (ON)
7 – Inhibit No Resp 30 Engineer 1 (ON)
9 – Panel Setup 30 Engineer 1 (ON)
8 – Configuration 30 Engineer 1 (ON)
1 – Change Text 30 Engineer 1 (ON)
2 – Insert Point 31 Engineer 1 (ON)
3 – Delete Point 31 Engineer 1 (ON)
4 – Modify Point 31 Engineer 1 (ON)
7 – Auto Config. 32 Engineer 1 (ON)
9 – Test Buzzer, LEDs & Display 32 No logon needed 0 (OFF) (using View
menu above) or 1 (ON)
Function See Page Login Level Enable Key
Table 4: Functions and required access levels (cont.)
*This function is not available in all countries or panel versions.
CAUTION
After use, do not forget to log off by
switching the Enable keyswitch to 0 (OFF),
and removing the key.
This will prevent unauthorised access to the
panel.
To Next Page
Loading...
