First Stop Safety MemoryPAT-Blu - Self Test; Self Protection

FIRST STOP SAFETY 28
MemoryPAT-Blu Issue 1.2
SELF TEST
The MemoryPAT-Blu has a built in self test feature. If the test voltages or currents
are outside the expected range, then it will not carry on with the testing and will
display an error message on the LCD display as shown below. If this were to
happen, then charge the battery for at least 1 hour and try again. If the problem
persists then please contact your supplier.
SELF PROTECTION
To prevent damage to internal circuits in case of accidental connection to mains
voltage, the MemoryPAT-Blu has self-protection built in. If it detects an excessive
voltage either to the IEC or the mains socket when a test button is pressed, the
following message is displayed and the tester will not carry out any of the tests.
Note: Even with this protection in place it’s possible to cause severe damage to
the MemoryPAT-Blu tester if mains voltage is connected either to the IEC or
mains test sockets. Please note that if the unit is damaged due to mains being
connected, this will invalidate any warranties that are provided with the unit.