Fisher & Paykel CLEANSMART 7 Series User Manual

33
CHANGING PRE-SET OPTIONS
Controlled Cold
If your incoming cold water temperature is very low you will get a less effective wash. The
CONTROLLED COLD option solves this problem by adding a small amount of hot water to
raise the temperature of the wash to approximately 20°C.
To programme the Controlled Cold temperature option:
2
Factory Reset
EOC Beeps
Wash Temp
OOB Recovery
Select the wash temperature you want to
adjust, eg WARM, by touching the WASH
TEMP button. The digital display screen
shows the current setting.
3
Touch MORE or LESS to increase or
decrease to the desired temperature. Each
increment is equal to approximately 0.5°C.
Factory Reset
EOC Beeps
Wash Temp
OOB Recovery
1
Factory Reset
EOC Beeps
Wash Temp
OOB Recovery
Enter the Option Adjustment mode, refer
to the ‘Option Adjustment mode’ for
instructions.
Select the
HEAVY cycle.

Fisher & Paykel CLEANSMART 7 Series Specifications

General

Brand	Fisher & Paykel
Model	CLEANSMART 7 Series
Category	Washer
Language	English