Lit. No. 94430/94431, Rev. 07 15 January 15, 2014
Variable Speed (PWM) Control – New Style
Starting and Stopping the Motor
1. To start the spreader motor, press the
START/BLAST button and release. Both the
START/BLAST and OFF buttons will be backlit
when the motor is running. The spreader will
operate at the speed selected on the speed dial.
2. Press the OFF button to stop the motor.
The OFF button operates as an emergency stop
when required.
NOTE: The truck ignition must be ON to start the
spreader.
NOTE: If the truck ignition is turned OFF while the
spreader is running, the motor will stop.
OPERATING THE SPREADER
CONTROLS
There are two control options. They include the
Variable Speed (PWM) Control and the ON/OFF
Control. Both have had design changes. Identify older
and newer styles by the face plate diagrams below to
nd the appropriate operating instructions.
WARNING
Before starting the spreader, the driver shall
verify all bystanders are a minimum of 25 feet
away from operating spreader.
Speed Dial
Speed Button
Indicator Light
OFF Button (emergency
CAUTION
If the unit is equipped with a SWING AWAY
®
mount, both hinge pins must be secured in
the base plates before operating the spreader
or the vehicle.
To Next Page
Loading...
