I
I
Analog Output Signals
Two analog outputs are available on the DPRSOO and
both deliver a 4-20 mA/O-20 mA signal proportional to
the 6100% selected output signal. The controller PID
output signal is always available at AOI. A02 is a re-
transmission of a user selected internal signal value.
Connect the analog output signal wires to terminals 9 and
10. Configure the output signal range using FCODE 116.
LmwW7-3
2.9
If an actuator position feedback potentiometer for a positioning
motor output is required as shown in the figure. The potentiometer
is connected to A01 where the current input will be supplied.
The negative input of any Al must be jumpered to
supply ground when the potentiometer setup is
used.
Digital Input Signals
All digital input signals (Dll thru D14) to the controller are isolated
by opto-couplers. The input current source may be from the
controller or from an external power supply as shown.
lJM6.1:DPR900:9102
Change 1 -September 1991
To Next Page
Loading...
