3-14
Controls and Indicators
[FISHER”)
Clearing an error code upon entering the
configuration mode, may not clear the code due to
required configuration changes. Upon completion
of these changes and exiting the programming
mode, the original error code may still be
observed. Re-enter the configuration mode a
second time to clear the error.
3.12 Bumpless Transfer
Switching between Auto and Manual is bumpless (unchanged) in both
directions. This does not apply if the DPRSOO is used as a simple
proportional (P) controller. In a P controller, the output signal in Auto is
always 50% when the process value is equal to the setpoint value.
Deleted
Change 7 -September 7991
To Next Page
Loading...
