4-4 Function Codes
To quickly view the current parameters, use the TUNE button. The
, @ ,
display alternately shows an FCODE, then the configured parameter
value. Enter the Programming mode and use only the TUNE button.
1cEqly
FCODE 1
FCODE 1 value is 1 .OO
1-l
FCODE 2
FCODE 2 value is 0.00
4.2.2 Function Selection
Function code 101 thru 145 are used in configuring the controller. The
controller must always be in the manual mode before any FCODE can
be selected. The programming procedure is identical to that described
above for tuning parameter changes, but instead of parameters,
option numbers (C-i-2-3-4-5) are set. Each number represents a
particular function.
When an FCODE is selected for display, the
function (number) currently in force is shown.
tJM&1:0PR900:9102
May 1997
To Next Page
Loading...
