햻
____________________________________
Re-Tune
If at any time during operation the F-Pulse alarms irregularly
or loses sensitivity, quickly press-and-release the button. This
Rapid Retune will return your pinpointer to stable operation.
Ground-Mineral Calibration
Calibrate the F-Pulse to operate in mineralized ground or
saltwater.
Calibration Procedure:
1.
Start with power on.
2.
Touch the tip of the probe to the soil, or submerge into the water.
3.
Quickly press-and-release the button.
4.
Unit responds with a beep confirming calibration is complete.
Interference (Frequency Shifting)
All metal detectors operate at different frequencies. It’s these
different frequencies that make certain detectors better at
detecting certain targets. The F-Pulse is designed to work with
the different frequencies of various detectors, and to enable the
user to calibrate the F-Pulse to a frequency that eliminates (or
minimizes) interference with your detector.
The factory default setting of the F-Pulse may interfere with your
metal detector, causing it or your pinpointer to beep irregularly.
OPERATION
To Next Page
Loading...
Need help?
General
