햹
____________________________________
Programming: Alarm and Sensitivity
The F-Pulse target alert can be audible, vibratory or both.
There are three different sensitivity levels: low, medium and high.
Default settings:
The default settings for this pinpointer are:
• LED: 70% brightness
• Alarm: Beep and vibrate
• Sensitivity: Medium
To program the alarm-type and sensitivity-level:
1. Start with power on.
2. Press-and-Hold the button.
Do not release the button at the first alarm (beep or vibrate).
If you release the button at the first alarm, the device
will turn off.
3. Following the power-down-alarm, hear the
programming-alarm: JINGLE-JINGLE-JINGLE.
4. Release the button when you hear JINGLE-JINGLE-
JINGLE
The device is now in programming mode
OPERATION
To Next Page
Loading...
